1E-30 Electric system (6WG1 (Common rail)) Legend 1. Connector 2. Screw A 3. Screw B Legend 1. IC regulator 2. Terminal bolt 3. B terminal 5. B Terminal ASM related Remove the connector & clamp. Remove the cap and nut from the rectifier terminal bolt. Remove the B terminal ASM by prying between the rear bracket and B terminal ASM. The tube remains on the rear bracket. Inspection Generator inspection and adjustment Stator Perform a visual inspection for damage, loose connections, and discoloration of winding wires. Check the conductance between the two stator coil lead wires (1) using a circuit tester. Replace the stator if there is no conductance. Caution: Do not lose the tube. 6.
Rectifier ASM related Remove the 1 rectifier Installation screw and 2 regulator Installation screws. Remove the stator and rectifier ASM together from the rear bracket. Then, remove the IC regulator. Remove the 4 stator coil lead wires, and remove the stator coil from the stator rectifier. Caution: The stator coil lead wires are soldered on to the rectifier terminal with high-temperature solder (230 ° C melting point specification). Super heat the rectifier, and without damaging the diode, use a 180 ~ 270 watt soldering iron to quickly (within approx. 5 seconds) remove the wires.