Electric system (6WG1 (Common rail)) 1E-31 Check the conductance between the stator coil lead wires (1) and core (2) using a circuit tester. Replace the stator if there is conductance. Rectifier ASM Inspect the conductance between the plus diode, plus side additional diode plus heat sync, and 4 diode terminals with a circuit tester. If there is conductance in both directions, the plus diode has a short circuit and the rectifier ASM must be replaced. If there is no conductance in either direction, the plus diode is open and the rectifier ASM must be replaced.
Minus diode and minus side additional diode Inspect the conductance between the minus heat sync and 4 diode terminals with a circuit tester. If there is conductance in both directions, the minus diode has a short circuit and the rectifier ASM must be replaced. If there is no conductance in either direction, the minus diode is open and the rectifier ASM must be replaced. Diode trio (3 small diodes) Use a circuit tester to inspect the conductance in both directions. If there is conductance in both direction or neither direction, the diode has a fault and the rectifier ASM needs replacing.
Rotor Inspect the bearing for abnormal noises, rattling, and leaking grease (if there is just a small amount of grease, it can be wiped off), and replace it if there is a fault. It is easier to check for abnormal noises and rattling if you check when the shaft is pushed into the main unit. Coil ASM Measure the resistance between both ends of the terminal in the terminal section. Replace the coil ASM if the measured value is outside the reference value. Legend 1. Plus diode 2. Diode terminal 3. Minus diode section