hitachi — Assembly

1E-32 Electric system (6WG1 (Common rail)) Caution: Be careful not to over-tighten screws, nuts, bolts etc. 4. Assembling the rear bracket, stator ASM and front bracket rotor The joint between the rotor bearing and rear bracket is tight. Heat the bearing box section of the rear bracket beforehand to 50~60 ° C, then assemble. After re-assembling the generator, rotate the pulley by hand and check that the rotor rotates smoothly. Front bearing Inspect the bearing for abnormal noises, rattling, and leaking grease (if there is just a small amount of grease, it can be wiped off), and replace it if there is a fault.

It is easier to check for abnormal noises and rattling if you check when the bearing is pushed into the bracket as opposed to checking the bearing by itself. Regulator The regulator cannot be tested with a circuit tester. After re-assembling the generator, test the generator and test whether the regulator is controlling the generator's voltage. Assembly Re-assembly can be done in the opposite order to disassembly, but the following cautions must be followed. 1. The bearing is filled with grease and sealed, so there is no need to apply oil or grease. Caution: The use of oil on the rotor shaft bearing that has a resin band is strictly prohibited.

Oil on the bearing box section of the rear bracket can cause creeping, and should be completely wiped off. 2. Use high-temperature solder (230 ° C melting point specification). Use a 180 ~ 270-watt soldering iron for soldering, perform the soldering work quickly (within approx. 5 seconds) and do not allow the rectifier to overheat. 3. Tightening torques for various sections Tightening torque reference list