hitachi — Installation

Lubricating system (6WG1 (Common rail)) 1H-9 Removal Important: Be careful when handling the oil jet's pipe as it deforms easily. Oil pan and oil jet removal procedure 1. Remove the oil pan. 2. Install the oil strainer bracket. 3. Install the O-ring to the oil strainer. 4. Install the oil strainer, and tighten in the numbered order shown in the diagram. Correct tightening torque: 49 N m {5.0 kgf m} 2. Remove the clearancer and bracket (oil pan). 3. Remove the gasket. 4. Remove the oil strainer. 5. Remove the O-ring for the oil strainer. 6. Remove the oil strainer bracket. 7. Remove the joint bolt for the oil jet. 8. Remove the oil jet. 5. Install the clearancer and gasket to the crankcase.

Apply approx. 3 ~ 4mm thickness and width of Three Bond TB1207B liquid gasket to the lower surface of the joints (1) of the cylinder block and flywheel housing, and of the gear case. Installation 1. Install the oil jet. Set the outward section of the oil jet to the positioning hole on the cylinder block, and fix it by tightening the joint bolt to the correct tightening torque. (6 places) Correct tightening torque: 70 N m {7.1 kgf m} Install the clearancer using gasket, and tighten in a clockwise direction starting with the center of the side. Lastly, re-tighten the bolts to the correct tightening torque. Correct tightening torque: 38 N m {3.9 kgf m}