1H-10 Lubricating system (6WG1 (Common rail)) Legend 1. Line connected to the bolt hole perimeter line (inner side) 2. Oil pan R finish line 3. Apply to the constant clearance along the oil pan angle R 6. Install the clearancer to the oil pan. Degrease the Installation surface of the oil pan flange side, flange R, and oil pan clearancer. Apply liquid gasket along the line on the diagram below. Liquid gasket: TB1207B Aim for a liquid gasket diameter of φ 4mm ( φ 3.5~ φ 4.5). Install the oil pan within 15 minutes of applying the liquid gasket.
If more than 15 minutes passes, use a gasket remover to completely remove all of the gasket, then re-apply the gasket and proceed to re-assemble the parts. When installing the oil pan, erect approx. 4 guide stands for positioning in the oil pan clearancer bolt holes. After tightening the oil pan, do not remove any of the protruding gasket from the inner or outer circumference of the oil pan. Do not fill the engine with oil or start the engine until at least 30 minutes has passed since the parts were installed. Legend 1. Aim to apply so that the edge of the gasket is on the R finish line 2.
Aim to apply the liquid gasket so that the edge of the gasket includes the bolt hole outer circumference