hitachi — Inspection

1H-14 Lubricating system (6WG1 (Common rail)) 6. Remove the oil relief valve. Inspection Oil relief valve Inspect the oil relief valve and spring for damage. 7. Remove the oil pump drive gear. Use a gear puller to remove the drive gear. Driven gear Measure the clearance between the pump body wall and gear. Clearance between body wall and gear Standard: 0.050 ~ 0.098mm Measure the clearance with the driven gear in the same way. 8. Remove the oil pump cover. 9. Remove the driven gear. 10. Remove the drive gear shaft. 11. Pay special attention to cleaning the inside of the oil pump body. Measure the clearance between the oil pump cover and gear. Clearance between cover and gear Standard:

0.040 ~ 0.094 mm