Lubricating system (6WG1 (Common rail)) 1H-15 Measure the outer diameter of the driven gear shaft and clearance between the shaft and pump body. Assembly 1. Apply a small amount of engine oil to the oil pump body wall. 2. Apply engine oil to the drive gear shaft and insert into the body. 3. Install the oil pump drive gear. Turn the drive gear in the same direction as shown in the diagram, and force it with a press until the gear end face is the same flat surface as the shaft head side. Measure the outer circumference and clearance of the drive gear side in the same way. Legend 1. Drive gear 2. Drive gear shaft Measure the interference of the shaft and drive gear. Interference Standard:
0.019 ~ 0.047mm Nominal dimension mm Selection of a reference point mm Limit mm Shaft outer diameter φ20 — φ19.9 Clearance between shaft and pump body — 0.04 ~ 0.074 —