1H-20 Lubricating system (6WG1 (Common rail)) 2. Pay attention to the direction of the seal ring when installing it. 8. Install the gasket to the oil cooler element. 9. Install the oil cooler element and tighten the nuts. Legend 1. Seal ring 2. Anti-rotation stopper 3. Oil thermo valve support Correct tightening torque: 25 N m {2.5 kgf m} Line up the anti rotation stopper section and install the oil thermo valve. 10. Install the water guide and tighten the screw. Correct tightening torque: 4 N m {0.4 kgf m} 3. Install the oil thermostat support. 4. Install the clearancer. 5. Install the oil thermostat. 6. Install the O-ring to the oil pipe. 7. Install the oil pipe and tighten the bolts. 11.
Install the cover and tighten the bolts. Correct tightening torque: 18 N m {1.8 kgf m} Correct tightening torque: 37 N m {3.8 kgf m}