Intake system (6WG1 (Common rail)) 1J-17 If the measured value is outside of the standard value, disassemble once again and investigate the cause. Clearance between back plate and wheel rear side Standard clearance 0.48 ~ 0.92 mm Caution: Always use 2 thickness gauges, and measure at the tips of the blades. Caution: The shaft cannot be installed to the compressor wheel after molybdenum disulphide has been applied to the shaft screw section. Set the dial gauge to the shaft & turbine wheel tip. Move the compressor wheel in the shaft direction and measure the amount of play. If the measured play value is outside of the standard value, disassemble once again and investigate the cause.
Shaft axis direction clearance 17. Apply grease to the O-ring (bearing case outer circumference) and install it. 18. Check the assembly direction of the compressor cover when installing it. Standard clearance: 0.075 ~ 0.155 mm Remove the turbine housing from the bearing housing, install the compressor cover, and take the following measurements. Using a thickness gauge, measure the clearance between the turbine back plate and rear side of the turbine wheel.