1J-16 Intake system (6WG1 (Common rail)) 14. Install the snap ring. Turn the taper side of the snap ring upwards, and install it to the bearing housing using snap ring pliers. Set the dial gauge to the shaft & turbine wheel tip. Move the shaft & turbine wheel in the shaft direction and measure the clearance between the shaft & turbine wheel and turbine housing. If the measured value is outside of the standard value, disassemble once again and investigate the cause. Shaft axis direction clearance Standard clearance: 0.39 ~ 1.0mm Caution: Do not make a mistake with the snap rings Installation direction.
Insert the snap ring into the bearing housing slot by gently tapping both division openings with a screwdriver. When tapping the snap ring with a screwdriver and hammer, be careful not to allow the screwdriver to hit the bearing housing. 15. Install the compressor wheel. Install the sub-assembled turbine housing to a vice. Wipe the end surface of the thrust ring and both end surfaces of the compressor wheel with dry tissue paper to completely remove dirt and oil. Install the compressor wheel. Caution: Wipe off all oil from the shaft's compressor wheel fit insert section. 16. Tighten the nuts. Apply molybdenum disulphide to the thread section of the locknut, and tighten to the correct torque.
Correct tightening torque: 20 N m {2.0 kgf m} Legend 1. Bearing housing 2. Snap ring