Intake system (6WG1 (Common rail)) 1J-15 Caution: Wipe the layered section of the shaft, and both end surfaces of the thrust ring with dry tissue paper to completely remove dirt and oil. 13. Install the insert. Legend 1. Insert 2. Piston ring 3. Oil deflector 4. Thrust sleeve 9. Install the oil deflector. 10. Apply grease to the O-ring inside the bearing housing and install it. 11. Install the piston ring to the thrust sleeve. Caution: When installing the piston ring to the thrust sleeve, do not allow the grease to become too spread, and do not twist the join section. Apply engine oil to the piston ring installed to the thrust sleeve.
Insert the thrust sleeve through the join section first and carefully install it. Take care not to damage or scratch the piston ring. 12. Install the thrust sleeve to the insert. Legend 1. Shaft 2. Compressor wheel 3. Nut section molybdenum application 4. O-ring section grease application