hitachi — Assembly

1J-14 Intake system (6WG1 (Common rail)) Assembly 1. Inspect the bearing housing for dirt, then set it. 2. Install the snap ring. Insert each of the snap rings into the bearing housing, and select the rounder shaped rings to insert first. Legend 1. Bearing 2. Snap ring 3. Bearing housing 4. Snap ring 5. Bearing 6. Turbine back plate 7. Piston ring 8. Shaft & turbine wheel Legend 1. Bearing 2. Snap ring 3. Bearing housing 4. Snap ring 5. Bearing Temporary assembly After assembly, temporarily install the bearing housing to the turbine housing, and temporarily tighten the coupling ASM. 3. Install the bearing. Apply engine oil to the inner and outer surfaces of the bearing and install it. 4.

Install the turbine back plate. 5. Install the piston ring to the shaft & turbine wheel. Apply engine oil to the piston ring, and install to the shaft & turbine wheel. Do not allow the oil to become too spread, and do not twist the join section. 6. Install the bearing housing to the shaft & turbine wheel. Caution: Do not over apply pressure or install to the shaft & turbine wheel when the core is not sticking out. Pressing in with too much pressure will cause damage to the ring and cause the shaft to bend. Take care not to damage the shaft & turbine wheel blades section. 7. Install the thrust ring. Caution:

Wipe the end surface of the thrust ring and both end surfaces of the thrust sleeve with dry tissue paper to completely remove dirt and oil. 8. Install the thrust bearing. Apply engine oil to the inner surface of the thrust bearing and install it.