hitachi — Components of injector checker

Electronic control fuel injection system (Common rail type) 1E-79 Each part of injector checker Do not turn the selection switch excessively after it is turned to stopper. Start switch This is used to stop the cylinder selected by the cylinder selection switch. Injection of selected cylinder stops approx. 2.4 seconds. 4 Operation lamp This comes on while injector is checked (approx. 2.4 seconds) after starting button is pressed. 3 5 2 Note: Do not use any switches and operate the machine while the lamp comes on. Otherwise, diagnosis result is not correct. 1 Holder TSWG0212 Holders are used to hang or fix the body. They are tightened on the body. To use the holders, loosen the screws to move.

Name 1. Main switch 2. Battery lamp 3. Operation lamp 4. Cylinder selection switch 5. Start button Note: When using or storing holders, be sure to tighten them to fix. Be careful not to tighten screws excessively. This may damage the body. Main switch This is used to switch ON and OFF of injector checker function. Note: Be sure to turn it to OFF before removing/installing harness. Battery lamp This comes on when the battery (9V) in the body gets low (7.2V or less). If the battery lamp comes on, replace the battery as soon as possible. (Refer to Battery Replacement) Note: When using the main switch, it comes on momentarily due to voltage change.

If the battery lamp does not come on when using the main switch, check the battery. Replace it if it gets low (7.2V or less). TSWG0221 Precautions on handling the body The body is a precision equipment. Do not drop it or make a high impact on it. The body is drip-proof type. However, avoid using it in rainy day or operating with wet hands to prevent water from entering through connector connection. Power for the body must be supplied from internal battery, not from external one. Prevent foreign matter from entering into the body while replacing battery. Cylinder selection switch This is used to switch a cylinder to be checked.

Turn it left fully before check, and then start to check clockwise (1 2 3 4 5 6). Note: One rotation of cylinder selection switch allow to check twice for each cylinder. At the third time or later, turn the selection switch left back to the original position and start to check.