1E-80 Electronic control fuel injection system (Common rail type) Do not use screws to tighten battery holder except original ones. This may cause body damage or battery damage and electric leakage. Do not disassemble the body in any circumstances. Contact Hitachi Construction Machinery. if it is faulty. 4. Connect the test harness to the engine side. Note: Be careful not to let the metal parts of test harness and connector contact glow plug connector. Protect it with cloth to prevent short during operation of key switch. Do not connect wrong connector.
(Confirm the identification tape (red) before connecting.) DTC will be detected if disconnecting or connecting the harness with the key switch to ON. Turn it to OFF during work. Injector test 1. Check the DTC. If DTC unrelated to injector is detected, repair or check to eliminate the faults before test. 2. Turn the key switch to OFF. 3. Disconnect the injector connector from engine on the machine. (4-cylinder: one, 6-cylinder: two) 4HK1 * 4HK1 is shown in the illustration. TSWG0215 Note: Be careful not to let the metal parts of connector contact glow plug connector while connecting the harness. TSWG0213 6HK1 #4,5,6 #1,2,3 TSWG0216 TSWG0223