hitachi — Components of injector checker

Electronic control fuel injection system (Common rail type) 1E-81 5. Connect the test harness to the body. Do not directly place the body on the engine. Avoid high vibration and impact. 15. Perform a test drive, and check that there are no faults. Battery Replacement 1. Remove the two screws on the side of the body. TSWG0214 6. Start the engine. 7. If the machine has function to lower idle speed, lower the speed to clarify the engine reaction. 8. Set the selection switch to “1”, and check the No. 1 cylinder. 9. Press the start button and check the engine vibration level and change in exhaust noise.

If it is difficult to recognize the change, touch the engine directly to check change in the vibration. TSWG0217 2. Pull out the battery holder. Note: Do not operate the body and the machine while the operation lamp comes on. 10. Confirm that the lamp goes off and repeat check of the remaining cylinders as steps 8 and 9. 11. Replace the injector in the cylinder of which engine vibration level and exhaust noise did not change. Note: For work procedure, refer to “Engine section” in the service manual. TSWG0218 12. Turn the key switch to OFF, remove the test harness, and restore the injector harness. Note:

DTC will be detected if disconnecting or connecting the harness with the key switch to ON. Turn it to OFF during work. 13. Start the engine and return the idle speed at specified one. 14. Clear the DTC. Refer to the machine’s manual for how to clear DTCs.