1E-82 Electronic control fuel injection system (Common rail type) 3. Remove the battery from the holder. Method to identify using non-contact infrared thermometer There are three methods to identify injectors as follows. Since the method varies depending on the necessary tools you have, and/or the judgment difficulty of each machine, refer to the section of Hitachi Construction Machinery . Method to identify 1. Method of judgment by an injector balance test using a diagnostic tool with KW or CAN communication such as Tech2. For the procedure of a balance test, refer to the “Injector balance test” in “How to use scan tool”. 2.
Method of judgment by such an injector balance test that the injector power line is broken for a short time using an injector checker without communication with the ECM. Refer to “How to use injector checker”. 3. Method of judgment by measuring and comparing the rising trend of the exhaust temperature using a non-contact infrared thermometer. TSWG0219 4. Disconnect the connector from battery, and replace the battery. Depending on machine types, proficiency may be required to judge only using an injector checker when a diagnostic tool is not available.
If it is difficult to judge, we recommend the method of measuring and comparing the rising trend of exhaust pipe temperature using a non-contact infrared thermometer. Method to measure Use a non-contact infrared thermometer capable of measuring 500 ° C (932 ° F), and continuously measure at a rated point (for excavators, the points on two pump relief) on the engine which you can stably measure. Measuring period should be 3 to 5 minutes after the engine stabilized. Measure and compare the exhaust pipe temperature of each cylinder, and judge as faulty cylinder if the temperature of certain cylinder is significantly lower than others. TSWG0220 5. Restore in the reverse order.
Comparing exhaust pipe temperature of engine unit alone Note: Prevent foreign matter from entering in while removing the battery. Do not tighten the battery holder screws excessively. Do not replace the battery holder screws with other than original ones. Be sure to use specified battery. Note: Reference for test on engine unit. Test results will show similar tendency when trouble occurs although variation may differ depending on machine type and measuring conditions. Note: Be careful not to continue the test condition for a long time. Otherwise the test result may be incorrect due to heat conduction of the exhaust pipe.