hitachi — Speed limit control

1E-94 Electronic control fuel injection system (Common rail type) Idling control UP While pressing the “UP” side of switch, the engine speed increases, resulting in increasing the idling speed. At warm-up operation, using the “Idling control selector switch” allows to control the lowest idling speed. Also, using the “Idling control selector switch” allows to automatically set the lowest idling speed to the optimum value according to engine coolant temperature. DOWN While pressing the “DOWN” side of switch, the engine speed decreases, resulting in decreasing the idling speed. However, the idling speed does not decrease below the lowest speed.

The engine speed controlled by idling control switch is stored in ECM when the key switch is turned to OFF. The same speed can be achieved at the next operation. Note: Since specifications vary depending on each machine. Available functions also vary. Idling control selector switch Using the “Idling control selector switch” allows to switch the idling control function. Speed limit control Speed limit control means that the engine control module (ECM) controls fuel injection amount, based on vehicle speed signal and engine speed, so that the machine speed does not exceed the setting value. The vehicle speed signal is sent from vehicle speed sensor to pulse matching box.

The pulse matching box corrects the signal to match with the machine, and sends it to ECM, meter, etc. The ECM recognizes the engine speed by the signal from crankshaft position (CKP) sensor. Idling control switch Using the “Idling control switch” allows to control the idling speed. Note: Refer to the machine’s manual for the locations of idling control selector switch and idling control switch. The highest speed varies depending on engine model, machine specifications and warm-up condition of engine. Meter, Other ECU Engine Fuel injection control Pulse matching box Engine speed signal Vehicle speed sensor