hitachi — Engine speed output to tachometer

Electronic control fuel injection system (Common rail type) 1E-95 Check for speed limit control To check whether the speed limit control on the machine is active, check blinking of diagnosis lamp. 1. Turn the key switch to OFF. 2. Turn the key switch to ON. 3. Diagnosis lamp illuminates for 15 seconds and then blinks three times. Key switch and Engine run ON OFF 1 1 sec Diag lamp 0 15 sec 3 times 1 sec TSWG0006 Note: If it does not blink, the speed limit control is not active. Engine speed output to tachometer The engine control module (ECM) outputs the engine speed pulse (4 pulses per engine revolution) as a tachometer output to tachometer.

Tachometer shows the engine speed using the engine speed pulse sent from ECM. CKP sensor Engine control module (ECM) CAN communication Engine speed Tachometer output on machine side Control unit Tachometer Output from machine control unit by machine TSWG0119