1E-96 Electronic control fuel injection system (Common rail type) Preheating control QOS (Quick On Start) system The ECM determines the period required for glow (pre- glow, glow, after-glow), and operates the glow relay and QOS indicator lamp. QOS system allows to make the starting at cold weather easier and reduce white smoke and noise at starting. When turning the key switch to ON, the ECM detects the engine coolant temperature by signal from engine coolant temperature (ECT) sensor and changes the period for glow so that the proper starting conditions can be achieved all the time. Also, after-glow function allows to stabilize idling immediately after starting.
Key switch (ON) Battery Glow relay Engine control module (ECM) Glow plug QOS indicator lamp LCD or Lamp) Engine coolant temperature sensor TSWG0007 Engine Control Module (ECM) The ECM monitors the information sent from various sensors all the time and controls each system of the powertrain. The ECM performs the diagnostic function of the system, detects operational problems of the system, gives a warning through diagnosis lamp to a driver and stores DTC (diagnostic trouble code). The area where the trouble occurred can be identified by the DTC to assist a mechanic to perform repair work. The ECM sends the voltage of 5 V to supply the power to various sensors or switches.
The ECM controls the output circuits by controlling the ground or power supply circuit through a certain device. About functions of ECM Note: Refer to the machine’s manual for the locations of ECM. ECM and components The ECM is designed to maintain the level of emission as the emission control regulations and get a good performance and fuel efficiency at the same time. The ECM monitors various functions of the engine through the sensors such as crankshaft position (CKP) sensor etc. TSWG0008