MAINTENANCE PROCEDURE 4.8.1.d RELEASING THE PARKING BRAKE q In case of failure of the hydraulic system and before re- moving the machine, release the negative brake in- stalled on the travel motors. The release of the parking brake is obtained by acting on the negative brake installed on the travel motors, according to the following procedure. 1 - Raise the cab (see "3.5.3.1 RAISING THE CAB"). 2 - Disconnect the pipe (1) that supplies pressure to the tra- vel motors. 3 - Connect the grease nipple (3) to the union (2). 4 - Using the grease pump provided, inject grease until rea- ching the minimum pressure required to release the brake.
5 - After releasing the brake, carry out the necessary mainte- nance operations. 6 - To restore the braking circuit to the standard configura- tion, remove the grease nipple (3) from the coupling (2) and put back the pipe (1). 1 7 - Lower the cab (see "3.5.3.1 RAISING THE CAB"). RWA36030 NOTE q After restoring the circuit to the standard configuration, it is not necessary to carry out any adjustment. 3 2 RWA36040 176 WARNING