MAINTENANCE PROCEDURE 4.8.8.c CLEANING THE WATER SEPARATOR q Change the precleaner at the end of work, when the engine has cooled down to 40-45є C. q When these operations are carried out, fuel may be spilled; clean the dirty areas immediately, in order to prevent any risk of slipping or fire. The water separator can be reached after opening the engine hood (see "3.5.1 ENGINE HOOD") and after lifting the loader arm and securing it with the safety lock (see "3.1.1 LOADER LOCKS"). CLEANING THE WATER SEPARATOR 1 - Close the cock (1). 2 - Loosen the metal ring (2) and remove the cup (3) and the filtering element. 3 - Clean the inside of the cup and the filter with diesel oil or oil.
4 - Put back the filter and the cup (3), tighten the metal ring (2) and open the cock (1). IMPORTANT q When disassembling the water separator, be careful not to lose the red ring contained in the cup. q If the filtering element is clogged or damaged, change it. BLEEDING THE CIRCUIT After filling the tank, turn the ignition key to position « » and wait for approximately 15-20 seconds, in such a way as to bleed the fuel supply circuit. IMPORTANT q After bleeding the circuit, turn the ignition key to posi- tion « » for a few seconds and wait at least 2 minutes before starting the engine.
q If the engine starts without problems and then stops or works irregularly, check if there is air in the circuit; if so, check the tightness of the fuel filter and of the fuel pump prefilter. 1 q After the fuel has run out, bleed the circuit by proceed- ing as described above and repeat the operation for at least 2-3 times. 2 3 RWA36750 RWA01970 RWA01960 195 WARNING