Komatsu — 4.8.8.d DRAINING THE HYDRAULIC OIL TANK (Only for machines filled with synthetic biodegradable oil type HEES)

MAINTENANCE PROCEDURE 4.8.8.d DRAINING THE HYDRAULIC OIL TANK (Only for machines filled with synthetic biodegradable oil type HEES) q Lower the loader arm completely, rest the bucket on to the ground and, after stopping the engine, eliminate the residual pressures that may be present in the equip- ment (by operating the controls more than once) and lock the safety bars (see "3.3.5 pos. 1 - SAFETY BARS"). RWA37070 q Let the oil cool down until it reaches 40-45єC before per- forming any maintenance operation. q Immediately clean any area dirty with oil.

Stop the machine on a firm and level surface, lower the equip- ment to the ground, stop the engine and release the residual pressures that may be present in the equipment by operating the controls more than once. Raise the engine hood (see "3.5.1 ENGINE HOOD") and open the rear panel (see "3.5.2 REAR PANEL"). 1 - Slowly loosen the filling cap (1) to release the residual pressure from the tank and remove it. 2 - Loosen the lower plug (2) until the condensate has flown out of the tank completely. Use a 12 mm hexagon spanner. 3 - Put back the lower plug (2), the filling cap (1) and close the rear panel and the engine hood.

IMPORTANT q The draining of the tank must be carried out at tempera- tures exceeding 0єC, before starting the engine; when the temperature is below 0єC, the hydraulic oil tank must be drained at the end of work, or in any case when the temperature of the machine is sufficiently high to pre- vent the condensate from freezing and to allow it to flow out of the tank without problems. 2 RWA34230 196 WARNING