MAN — Removing and installing crankshaft

Removing and installing crankshaft Checking axial play Fig. 9 The axial play of the crankshaft is determined by the centre crankshaft bearing (thrust bearing). 9 3550 Fig. 10 D Fit dial gauge holder with dial gauge to crank- case. D Move crankshaft in axial direction to and fro and read off play on dial gauge. D If permissible axial play is exceeded, replace main bearing shells complete. 10 3725 Fig. 11 Measure connecting rod bearing, insert pistons with connecting rod. Coat connecting rod bearing shells with oil and pull connecting rods to bearing pin. Mount connecting rod bearing caps with bearing shells (observe marking - numbers must be on the same side).

Screw in mounting bolts and tighten in stages to specified torque. Tighten finally by angle. (For tightening torques and reusability of bolts, see ”Engineering S Data S Setting values”.) 11 4391 99