Removing and installing piston with connecting rod Removing piston with connecting rod D Remove oil pan, oil suction pipe, see page 51 D Remove cylinder heads, see page 74 Fig. 1 Remove bolts from connecting rod bearing cap. 1 3724 Fig. 2 Take off connecting rod bearing caps with bearing shells, expediting the procedure by means of light strokes with a synthetic hammer if necessary. Note: Connecting rod bearing caps are match- marked with the connecting rod big ends; arrange them in corresponding order. 2 3553 Fig. 3 Remove combustion residues (oil carbon) from top cylinder edge using a piece of hard wood. Caution: Do not damage cylinder liners.
Push out connecting rod with piston in upward direction. Caution: Do not damage oil spray nozzles. 3 3554 Fig. 4 Lay pistons with connecting rods and associated caps aside; use deposit rack if available. Inspect pistons and piston rings visually. Note: For reworked crankcase sealing faces re- pair pistons with undersizes of 0.2, 0.4 and 0.6 mm in the compression height are available (see ”Engineering S Data S Set- ting values”). 4 4229 100