Removing and installing injection pump Removing injection pump D Close cut-off valve from fuel tank to engine. Note: The subsequent reinstallation of the injec- tion pump is rendered considerably easier if before its removal the engine has been turned to start of delivery. See chapter “Adjusting start of delivery” on page 25. Fig. 1 1 4296 Remove all fuel lines from injection pump. Caution: The lines contain fuel. Catch emerging fuel in a suitable con- tainer. Fig. 2 Remove injection-lines. 2 4295 Fig. 3 After removal of the injection lines we recommend fitting caps to the connections on the injection nozzles and injection pump. This prevents dirt from getting into the injection system.
Caution: Dirt in the injection system causes: D nozzles to jam D the injection-pump drive gear to break 3 4294 Fig. 4 Remove holders from injection pump. 4 4297 28