MAN — Assembling water pump

Repairing water pump Fig. 8 Press impeller on to bearing shaft. For this purpose place water-pump bearing shaft on a stable support. The correct gap dimension (see ”Engineering S Data S Setting values”) is achieved if the outer face of the impeller is flush with the front face of the bearing shaft. Check the gap dimension with the feeler gauge. The impeller must be easy to turn and must not contact the water-pump housing. 8 3439 Fig. 9 Turn pump housing over and align it horizontally on a suitable support. Press hub on to the bearing shaft until flush. For this purpose place bearing shaft together with the flush-fitting impeller on a stable support. 9 3586 45