Oil spray nozzle Removing oil spray nozzle D Drain engine oil D Remove oil pan, see page 51 Fig. 1 Remove oil spray nozzle valve (arrow) and take out oil spray nozzle. 1 3462 Fig. 2 1 Oil spray nozzle valve 2 Oil spray nozzle 2 Note: The oil spray nozzles are provided with two balls. When the oil spray nozzles are tightened at the factory the balls are pressed into the crankcase where they make impressions used as marker points for the installation of oil spray nozzles in the event of repair work. 1 2 3463 Checking oil spray nozzle valve Fig. 3 Use a piece of wire to check whether the valve piston is easy to move. For opening pressures, see ”Engineering S Data S Setting values”.
3 3673 Installing oil spray nozzle Fig. 4 Screw in the oil spray nozzle together with the oil spray nozzle valve. The balls of the oil spray nozzle must be located in the impressions provided for this purpose in the crankcase. This will ensure that the oil spray nozzle will be installed in the correct position. Turn the engine over. Neither the crankgear nor the pistons must collide with the oil spray nozzle. Tighten the mounting bolts to the specified torque. 4 3465 54