Checking axial and radial play of turbocharger rotor shaft D Remove turbocharger, see page 71 D Mark turbine housing relative to the bearing housing and remove turbine housing. Axial play Fig. 1 Remove turbocharger. Mark turbine housing rela- tive to the bearing housing and remove turbine housing. Apply dial gauge holder and dial gauge under pre- load to shaft end face of the turbine wheel as shown. 1 3742 Press rotor shaft against dial gauge. Read and note down value. Push rotor in opposite direction. Read and note down value. The difference between the two is the axial play. Change turbocharger if axial play is exceeded. Radial play Fig.
2 Radial play is measured only on turbine end with dial gauge or feeler gauge. Apply dial gauge tip to side of hub. Push turbine wheel towards dial gauge. Read and note down value. 2 3743 Push turbine wheel in opposite direction. Read and note down value. The difference between the va- lues is the radial play. Place turbine housing in position, observe mark- ings and screw on turbine housing. 73