MAN — Removing and installing timing case

Removing and installing timing case D Remove starter, see page 111 D Remove speed pickup, see page 119 D Remove flywheel, see page 58 Fig. 1 Remove the mounting bolts. The bottom of the timing case is bolted to the oil pan. 1 3536 Fig. 2 Take off the timing case. Take the gasket off the timing case and fit a new one. 2 3537 Fig. 3 Check the contact washer on the camshaft for wear, if necessary fitting a new one. 3 3538 Fig. 4 Stick new gasket to timing case using grease. Fit flywheel housing. Check whether the oil-pan gasket is in order, if necessary fitting a new one.

Slightly oil the threads and the contact faces of the mounting bolts and tighten the bolts to the speci- fied torque (see ”Engineering S Data S Setting va- lues”). 4 3539 93