MAN — Removing and installing camshaft, exchanging camshaft bearing

Removing and installing camshaft, exchanging camshaft bearing Removing camshaft D Drain coolant, see page 38 D Remove oilpan, see page 51 D Remove starter, see page 111 D Remove flywheel and timing case, see page 93 D Remove the rocker arms and take out the push rods, see page 74 Note: For removing the camshaft the engine must be turned by 180 _ . For this reason the engine must be placed on a dolly. 1 3542 Fig. 1 Turn engine upside down so that the valve tappets do not obstruct removal of camshaft. Pull out camshaft, taking care not to damage the camshaft bearings. Check camshaft for wear and damage.

If the camshaft or the drive gear is damaged, a new entire camshaft/gear unit must be fitted. Check the tappets, if necessary fitting new ones. 2 3719 Fig. 2 Remove valve tappets and check them for wear, changing them if necessary. The valve tappets can be removed only after removal of the camshaft. Exchanging the camshaft bearings Remove the cylinder heads, the pistons with the connecting rods and the crankshaft, before remov- ing camshaft bearings. Fig. 3 3 3543 Remove camshaft bearing bushes with suitable mandrel and drive in new bushes. Ensure that the oil supply bores are in correct position. 94