MAN — Removing and installing crankshaft

Removing and installing crankshaft Removing crankshaft D ,Remove oil pan and oil pump see page 51 D Remove timing case, see page 93 D Remove the front cover for sealing the crank- shaft and the cylinder heads, see page 74 Fig. 1 Remove bolts from connecting rod bearing caps, take out connecting rods with pistons and arrange them in order of installation. 1 4390 Fig. 2 Loosen and remove mounting bolts from crank- shaft bearing caps in stages from the inside out. Take off bearing caps and arrange them in order of installation. Take the bearing shell halves out of the bearing caps and lay them aside together with their re- spective bearing caps. 2 3548 Fig. 3 Lift out crankshaft. Caution:

Do not damage the rolling surfaces of the crankshaft bearing pins. 3 3589 Fig. 4 Take the bearing shells out of the crankcase and lay them aside in the sequence of installation. Clean parts and check for wear, replacing them if necessary. 4 3550 97