Liebherr — R934B_en_sn_17227.mdi

MACHINE MAINTENANCE SAFETY The machine may not be made unsafe when performing maintenance work. Never attempt maintenance procedures or repairs you do not understand. Before any repairs or maintenance work, clean any oil, fuel and / or cleaning substances from any fittings and connections. Don’t use any harsh cleaners and use only lint free cloths. Check the Operator’s and Maintenance Manual for service and maintenance intervals. Make sure you use only appropriate tools for all maintenance work. Use only non-flammable cleaning fluids to clean the machine. Refer to your Operator’s and Maintenance Manual to see, who is authorized to perform certain repairs.

The operator should only perform the daily / weekly maintenance procedures. Any welding, torch or grinding work on the machine must be explicitly authorized. Written authorization is necessary for welding on carrying structures. Before any using a welder, torch or grinder, clean off any dust and dirt and remove any flammable materials from the surrounding area. Make sure the area is sufficiently ventilated. Danger of Fire and Explosion! The remaining work may only be performed by especially trained personnel. Use only replacement parts corresponding to the technical requirements specified by the manufacturer. This is assured by using only original Liebherr replacement parts.

Before cleaning the machine with water or steam (high pressure cleaning) or other cleaning fluids, make sure that all openings, which, for safety and/ or functioning reasons should not be exposed to water / steam / cleaners, are covered and / or masked off. Especially sensitive are electrical motors, control boxes and plug connectors. Always wear proper work clothing when maintaining the excavator. Certain work may only be performed with a hard hat, safety shoes, safety glasses and gloves. During maintenance, do not allow unauthorized personnel to enter the maintenance area. Secure the maintenance area, as necessary.

Make sure that the temperature sensors of the fire alarm and extinguishers system do not come in contact with the hot cleaning fluids, which could trigger the fire extinguishing system. Remove all coverings and masking material after completing the cleaning procedure. Then check all fuel lines, engine oil lines and hydraulic oil lines for leaks, loose connections, chafing and / or damage. Fix any problems immediately. Inform the operator before any special or maintenance work. Make sure he knows the person, who is in charge of the work.

If not otherwise noted in the Operation and Maintenance Manual, always make sure the excavator is parked on firm an level ground and the engine is turned off. During maintenance and service work, make sure you always retighten any loosened screw connections! If you use a high pressure cleaner with steam or hot water to clean the machine, observe following recommendations:

- the distance between the nozzle and the surface to be cleaned must be no lower than 20 inches - the water temperature should not exceed 60°c (140°F) - limit the water pressure to 80 bar maximum (11500 PSI) - if you employ cleaning fluid, only use neutral cleaning agents such as customary car shampoos diluted to 2 or 3 percent maximum If it is necessary to disconnect or remove any safety devices during set up, maintenance or repair, make sure that after completion of repairs, the safety devices are reinstalled and checked for proper function. Before any maintenance work and especially when working under the machine, make sure a ”Do not operate’ tag is attached to the starter switch.

Remove the ignition key. After end of maintenance works or repair, restart the machine according to the instructions "Machine start up", in this manual. Never employ high pressure cleaning apparatus during the two first months following machine delivery or repainting. 6.1