Liebherr — R934B_en_sn_17227.mdi

Observe all product safety guidelines when handling oils, grease, and other chemical substances. Always support the raised machine in such a way that any shifting to the weight change will not influence the stability. Do not support the machine with metal on metal support. Make sure service fluids and replacement parts are disposed of properly and in an environ-mentally sound manner. Only qualified, especially trained personnel may work on travel gear, brake and steering systems. When using hot service fluids, be very careful. (They can cause severe burns and injury!). Operate combustion motors and fuel operated heaters only in well ventilated areas.

Before operating these units, check ventilation. In addition, always follow applicable local regulations. If it becomes necessary that the machine must be repaired on a grade, block the chains with wedges and secure the uppercarriage to the undercarriage with the lock pin. Only qualified, especially trained personnel may work on the hydraulic system. Never try to lift heavy parts. Use appropriate lifting devices with sufficient load carrying capacity. When replacing or repairing parts or components, make sure they are mounted very carefully on lifting devices, to prevent any possible danger.

Use only suitable and technically sound lifting devices, make sure that lifting tackle, wire cables, etc. has adequate load carrying capacity. Never position yourself, walk or work underneath suspended loads. Never check for leaks with your bare hands, always wear gloves. Fluid escaping from a small hole can have enough force to penetrate the skin. Never loosen or remove lines or fittings before the attachment has been lowered to the ground and the engine has been turned off. Then turn the ignition key to contact position with tilted down safety lever, move all servo controls (joysticks and foot pedals) in both direction to release pressures.

Then release the tank pressure as outlined in this Operation and Maintenance Manual. Never use damaged lifting devices, or devices which are not sufficient to carry the load. Always wear gloves when handling wire cables. Always disconnect the battery cable before working on the electrical system or before any arc welding on the machine. Always disconnect the negative (-) cable first and reconnect it last. Ask only experienced personnel to attach loads and guide and signal the crane operator. The guide must be within the visibility range of the operator and / or must be in direct voice contact with the operator. Check the electrical system regularly.

Make sure that any problems, such as loose connections, burnt out fuses and bulbs, scorched or chafed cables are fixed immediately by an electrician or qualified personnel. When working overhead, use appropriate and safe ladders, scaffolding or other working platforms designated for that purpose. Never step on parts or components on the machine when maintaining or repairing items overhead. When working high above ground, make sure you are fitted with ropes and appropriate safety devices which will prevent a possible fall. Always keep handles, steps, railings, platforms and ladders free of dirt, snow and ice! Use only Original fuses with the specified amperage.

Never use a different size or stronger fuse than the original fuse. On machines with electrical medium or high voltage systems: - If there is any problem with the electrical energy supply, turn the machine off immediately. - Follow established lockout / tag out procedures where applicable. - Any work on the electrical system may only be performed by a qualified electrician or qualified personnel under the guidance and supervision of an electrician, according to electro - technical regulations. When working on the attachments, for example when replacing the bucket teeth, makes sure the attachment is supported properly. Never use metal on metal support!

For safety reasons, never open and remove a track chain unless having previously totally released the pretension of the chain tensioning unit. Never work underneath the machine if it is raised or propped up with the attachment. The undercarriage must be supported with wooden blocks and supports. 6.2