Liebherr — R934B_en_sn_17227.mdi

LIFTING TACKLE INSERT The standard hydraulic quick change coupler comes equipped with two integrated load hooks (fig. 17, pos. g). The hydraulic excavator may only be operated with lifting tackle when the additional safety devices described in chapter 4 “lifting tackle“ are present and operational. DANGER Never use attachment hook pos. c to fix loads because the attachment hooks do not provide any secure hold for load attachment items such as cables or chains. 17 The maximum load capacity of each individual load hook can be found on the quick change coupler.

The load capacity of the quick change coupler and/or the integrated load hook can be less than or greater than the load capacity of the basic machine. During operation, make sure that the values found on the load capacity chart and in the Technical Data of the basic machine are maintained when checking the authorized load capacity of the coupler and/or the integrated load hook. Any load lifting work can only be performed when the tool is attached or dismantled. When the tool is dismantled, it is recommended to fully retract the locking pins on the lifting tackle insert.

This prevents the load attachment items (cables, chains) from being routed over the locking pins and thus protects them from being damaged. If the overload warning device is switched on, the warning buzzer for the retracted locking pins can be turned off via switch S349 (fig. 19) to prevent any constant noise pollution. The symbol “locking retracted“ remains visible/lit up on the instrument panel. The warning buzzer is reactivated automatically when the locking pins are actuated again. 19 8. 2.7