Rotating switch S114 - Control of special attachments with the rocker switch S55 on joystick This switch allows to flip the control of certain attachment from the pedals normally foreseen to this effect, via the rocker switch S55 on the left joystick. When the switch is in position "joystick", special attachments as hydraulic hammer or scrap shear are controlled via the three positions rocker switch S55. With the switch turned to position "pedal", these attachments are controlled using the pedals 7c and 7d, as described on pages 4.15 and 4.16.
With machines featuring several additional consumers, two different consumers can be allocated to the same hydraulic circuit (servo control circuit and consumer output on the spool valve). Switch-over of the hydraulic circuit from one consumer to the next is resulted via rotating switch S117. Should it be necessary to supply both consumers with different amounts, the necessary adaptation of flow limitation is resulted simultaneously upon pre-selection with the rotating switch. In one position of the rotating switch (turn symbol, example for the drive of a swivel bearing), control light H40 lights up simultaneously.
Rotating switch S117 - Pre-selection hydraulic circuit Push button S160 - Control of reversible fan in opposite direction On machines fitted with the special equipment "cooler fan reversible", the direction of revolution of the cooler fan can be inverted while actuating the push button S160. In some particular working conditions, this inversion of the direction of the fan rotation allows an easy cleaning of the radiator core and of suction area of the fan. Cleaning procedure: With running Diesel engine depress the push button S160 and keep it depressed. During approx.
15 seconds the fan will be progressively stopped, then the control light H90 lights up and the fan will start rotating in opposite direction, bring the Diesel engine to high idle while keeping the push button S160 depressed, let the engine run at high idle for approx. one minute, (three minutes at the maximum), release the push button S160, To check the condition of the cooler, the Diesel engine must be shut down. If necessary repeat the cleaning procedure. Key switch S168 - Oil flow limitation when operating a super long working attachment This key switch allows to limit the speed of the whole working attachment.
When using a super long working attachment, the key switch S168 must be turned to position "1", so to keep the speed of all attachment movements within reasonable limits. Notice: To limit all the excavator movements, not just the movements of the working attachment, use the push button S354 of the control unit, refer to page "control unit". Push button S210 - Cold start aid "startpilot" The Push button S210 controls the cold start system. When the button is depressed, an ether based starting fluid is sprayed into the air inlet manifold of the Diesel engine. At the same time, the green control light inside the push button will light up.
The cold start system cannot be actuated if the engine is running or at operating temperature. 3.22 .0