Code key switch S74 - Anti-theft protection system The Auto-Scan protection unit interrupts the current supply of the excavator about 30 seconds after shut down of the machine (ignition key in 0-position), the red LED lights up. To restart the machine, a code key must be stuck briefly in the anti-theft system S74 to unlock the protection. The red LED will then turn off and the electrical system must be energized immediately thereafter (ignition key in contact position). Touch S76 - Travel parking brake This touch controls the travel parking brake on the machines fitted with a special undercarriage, or on machines mounted on a loading bridge, a wagon, ...
When the red indicator light in the touch lights up, the travel brake is applied. On machines with a standard undercarriage, the travel brakes are controlled directly via the travel pedals and the touch S76 does not exist. Touch S77 - Pressurized driver's cab Depressing this button start the air fan for the pressurization of the driver's cab. The entering of dust or no filtered air into the cab is then almost prevented.
Touch S79 Flow divider for special attachment Should a certain user (cylinder, hydraulic motor, ) has to be supplied with a constant oil flow during the actuation of a special attachment, so the necessary oil flow can be reserved to give priority to this user while depressing the touch S79. The indicator light in the touch is then lighting up. The speed of the other simultaneously actuated working movements is correspondingly reduced. Push button S84 - Central lubrication system On machines fitted with a central lubrication system, an additional lubrication cycle of the attachment bearing points and swing ring can be started by depressing the button S84 (see on pages 5.21 to 5.23).
Touch S98 - Low pressure protection for boom cylinders The touch S98 allows the actuation of the pressure protection of pressure relief valve in the circuit for retraction of the boom cylinders is reduced, so to limit the possible downward thrust exerted by the working attachment onto the materials to be digged out. This device is actuated by switching on the touch S98 and by tilting up or down the rocker switch S55 (see drawing 60 page 4.15). This safety device must be turned on, as an example, when unloading a boat or a barge, so to avoid damage to its bottom.
Touch S104 - Hydraulic width adjustment of undercarriage This button concerns excavators fitted with an undercarriage with adjustable track gauge. The button must be actuated before moving the side frames. - On machine type HV (excavators with fully hydraulic actuated track gauge adjustment), pushing the button commutes the high pressure circuit in the undercarriage from travel control to the width adjustment cylinders (see page 8.5.7). 3.21