Liebherr — R934B_en_sn_17227.mdi

Control light H40 - Pre-selection hydraulic circuit This lamp reports pre-selection of a certain consumer via rotating switch S117. Control light H90 / Rotation in opposite direction of reversible fan On machines fitted with the special equipment "cooler fan reversible", this control light lights up to indicate that the fan has been changed over to rotation in opposite direction via the push button S160. Control light H292 - Special control system This control light lights up to indicate that a special, non standard lever arrangement has been turned on via the key switch S247.

Touch S26 - Fuel pre-heater This button turns on the installed fuel heating system (Thermoline fuel hose, or heater resistor inside the fuel filter). The Control light inside the push button shows when the heating system is on. Touch S40 - Frequency commutation for hydraulic hammer This touch allows to increase the cycle frequency of an hydraulic hammer. Touch S46 - Operation with a lifting magnet This button turns on the generator which supplies the lifting magnet, and also switches on the control circuit of the magnet (push buttons S6 at the top of the right joystick handle, see also page 4. 17). The control light inside the touch lights up when the control circuit is on.

In this case, the engine idle automatic is deactivated; the engine RPM is automatically set to a fixed value and can not longer be set using the buttons S228, S229 and S86. Touch S53 - Special control circuit supply When this touch is actuated, an additional control circuit for a special equipment is made alive. The green indicator light in the touch lights up to show that the additional servo control circuit is under pressure. Key switch S54 - Unlocking of cylinder end position On some special working attachments, or on attachment showing particular cinematic capacities (as example on industrial attachment), certain movement(s) may be stopped automatically by electrical end switches.

The main purpose of this movement limitation is to prevent possible damages due to components frequently reaching their end stops. With the key switch S54 turned to the left into position I, the automatic limitation can be unlocked temporarily while tilting up or down the rocker switch S55 mounted to the left joystick handle (see page 3.2). Notice : on machines destined to the north-american market and also fitted with a lifting magnet controlled via the rocker switch S55, the both push buttons S5 at top of the left joystick handle must be used to unlock the limitation.

Should a special attachment comprise two different automatic stops of movement, so the key switch S54 must be turned to the right into position II to be able to release from the second automatic limitation. No unlocking is possible with the switch S54 in neutral position. 3.20 Key switch or touch S47 - Quick change adapter The switch S47 turns on the control circuit for the quick change adapter for the working tool. The locking pins of the adapter can then be retracted or extended using the both push buttons S5 on the top of the left joystick handle. (Also see on chapter 8.2).