Kaiyi — Kaiyi Hydraulic Systems Maintenance Manual

6-42 Item Description Service action Bucket rollback circuit relief valve check Position bucket at a 45˚ angle against an immovable object. Engage transmission in 3rd speed forward. LOOK : Bucket angle must not change. OK Check complete. NOT OK Replace boom lower check valve. Bucket dump circuit relief valve low pressure check Raise front of machine which bucket at 45˚ angle. Backdrag with bucket while observing bucket angle. LOOK : Bucket must not rollback OK Go to next check. NOT OK Do loader system and circuit relief valve test at page 6-57. Pilot control valve float check Run engine at low idle. With the bucket partially dumped, lower boom to raise front of machine.

Push control lever to the float detent position and release lever. LOOK : Front of machine lower to the ground and valve must remain in float position when lever is released. OK Check complete. NOT OK Do pilot control valve pressure test in group 3. B o o m c y l i n d e r a n d bucket cylinder drift check Heat hydraulic oil to operating temperature. Set the boom and bucket horizontal, then stop the engine. Stop the engine, wait for 5 minutes, then start measuring. Measure the amount the lift and dump cylinder rods retract during 15 minutes. (unloaded bucket) A : Retraction of boom cylinder B rod B :

Retraction of bucket cylinder A rod Boom cylinder must drift less than 15 mm Bucket cylinder must drift less than 24 mm OK Check complete. NOT OK Go to next check.