6-48 Problem Cause Remedy Function drifts down Leaking cylinders. Leaking seals in circuit relief valve (port relief valve) or valve stuck open. Leaking loader control valve (MCV). Do cylinder leakage checks in group 3. Inspect seals. Replace relief valve. Repair or replace valve section. Boom drifts up Leakage in boom down spool. Remove and inspect boom down spool. Boom down does not work (engine off) Safety valve not operated. Stuck pilot control valve. Faulty line filter. Accumulation not operated. MCV spool stuck. Operate valve. Inspect. Remove and inspect filter. Inspect. Inspect and repair valve. Oil overheats Low oil viscosity in hot weather. Excessive load.
Holding hydraulic system over relief. Leakage in work circuit. Plugged fins in oil cooler. Internally plugged oil cooler. Incorrect system or circuit relief valve setting. Restriction in oil lines or loader control valve (MCV). Malfunctioning steering valve. Leaking system main relief valve. Worn hydraulic pump (internal leakage). Use recommended oil. Reduce load. Reduce load. Do boom and bucket cylinder leakage test in group 3. Inspect and clean oil cooler. Do hydraulic oil cooler restriction test. Do loader system and circuit relief valve pressure test in group 3. Inspect for dented or kinked lines. Do hydraulic system restriction test in group 3.
Do hydraulic system restriction test in group 3. Remove and inspect valve and seals. Do hydraulic pump performance check in group 2. Function drops before raising when valve is activated Stuck open lift check valve. Do control valve lift check in group 2.