100 SEBU8726-03 Maintenance Section Engine Oil Sample - Obtain Note: Ensure that the engine is either level or that the engine is in the normal operating position in order to obtain a true level indication. Engine number Service hours on the engine Note: After the engine has been switched OFF, wait for 10 minutes in order to allow the engine oil to drain to the oil pan before checking the oil level. The number of hours that have accumulated since the last oil change The amount of oil that has been added since the last oil change 1. Maintain the oil level between the MIN mark and the mark MAX on the engine oil dipstick. Do not fill the crankcase above the MAX mark.
Ensure that the container for the sample is clean and dry. Also ensure that the container for the sample is clearly labelled. NOTICE Operating your engine when the oil level is above the MAX mark could cause your crankshaft to dip into the oil. The air bubbles created from the crankshaft dip- ping into the oil reduces the oils lubricating character- istics and could result in the loss of power. To ensure that the sample is representative of the oil in the crankcase, obtain a warm, well mixed oil sample. To avoid contamination of the oil samples, the tools and the supplies that are used for obtaining oil samples must be clean. 2. Remove the oil filler cap and add oil, if necessary.
Clean the oil filler cap. Install the oil filler cap. If an increase in the oil level is noticed, refer to Troubleshooting, “Oil Contains Fuel”. The sample can be checked for the following: the quality of the oil, the existence of any coolant in the oil, the existence of any ferrous metal particles in the oil and the existence of any nonferrous metal particles in the oil. i01907674 Engine Oil Sample - Obtain i06707128 Engine Oil and Filter - Change The condition of the engine lubricating oil may be checked at regular intervals as part of a preventive maintenance program. Perkins include an oil sampling valve as an option.
The oil sampling valve (if equipped) is included in order to regularly sample the engine lubricating oil. The oil sampling valve is positioned on the oil filter head or the oil sampling valve is positioned on the cylinder block. Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. Perkins recommends using a sampling valve in order to obtain oil samples. The quality and the consistency of the samples are better when a sampling valve is used. The location of the sampling valve allows oil that is flowing under pressure to be obtained during normal engine operation.
NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. Obtain the Sample and the Analysis Dispose of all fluids according to local regulations and mandates. NOTICE Keep all parts clean from contaminants. Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. Contaminants may cause rapid wear and shortened component life.
In order to help obtain the most accurate analysis, record the following information before an oil sample is taken: The engine oil service reset procedure must be completed after the engine oil, and filter have been changed. Refer to “Engine Oil Service Reset” for more information. The date of the sample Engine model