SEBU8726-03 99 Maintenance Section Engine Mounts - Inspect 2. If necessary, remove breather pipes on cover (6). Remove nuts (7) and remove cover (6) from housing (1). 4. Install the guard, refer to OEM. i02323089 Engine Mounts - Inspect 3. Remove circlip (4) and remove the breather element (3) and discard. 4. Remove the O ring seal (5) from the cover. Install the Breather Element Note: The engine mounts may not have been supplied by Perkins. Refer to the OEM information for further information on the engine mounts and the correct bolt torque. Ensure that all the components are clean and free from damage. Inspect the engine mounts for deterioration and for correct bolt torque.
Engine vibration can be caused by the following conditions: Incorrect mounting of the engine Deterioration of the engine mounts Loose engine mounts Any engine mount that shows deterioration should be replaced. Refer to the OEM information for the recommended torques. i04728471 Engine Oil Level - Check Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. Illustration 58 g02827300 Typical example (A) Diameter (B) Diameter 1. Install a new O ring seal (5) onto the cover (6). Note: The breather element must have the correct orientation before installation. Diameter (A) is visibly larger than diameter (B). 2.
Install diameter (A) of the breather element (3) onto the shaft (2). When correctly installed the part number of the breather element will be visible. 3. Install circlip (4) and cover (6). Install nuts (7) and tighten to 25 N·m (18 lb ft). If necessary, install breather pipes to cover. Illustration 59 g02829378 Typical example NOTICE Perform this maintenance with the engine stopped.