Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

102 SEBU8726-03 Maintenance Section Engine Oil and Filter - Change Vertically Up Oil Filter Illustration 63 g02829378 4. Remove the engine oil level gauge to check the oil level. Maintain the oil level between the MIN mark and MAX mark on the engine oil level gauge. Do not fill the crankcase above the MAX mark. Engine Oil Service Reset Illustration 62 g02596778 (4) Vertically up oil filter Some oil filters may be installed vertically up. Use the same procedure to replace the oil filter. Ensure that all the oil has drained from the filter before removal. NOTICE Failure to perform a schedule oil and filter service with an engine oil service reset will trigger an engine derate.

Fill the Oil Pan The low oil warning lamp has two functions. The lamp on solid will indicate that the engine has low oil pressure. The lamp flashing will indicate the engine oil and filter MUST be changed and the engine oil service reset MUST be completed. The lamp will only flash with the key in the ON position, with the engine in operation the lamp will be extinguished. 1. Remove the oil filler cap. Refer to this Operation and Maintenance Manual, “Fluid Recommendations” for more information on suitable oils. Fill the oil pan with the correct amount of new engine lubricating oil. Refer to this Operation and Maintenance Manual, “Refill Capacities” for more information on refill capacities.

Note: If the engine oil and filter have been changed before the warning lamp has started to flash, the engine oil service reset procedure MUST still be completed. Upon completion of the reset procedure, the lamp will flash three times. NOTICE If equipped with an auxiliary oil filter system or a re- mote filter system, follow the OEM or the filter manu- factures recommendations. Under filling or over filling the crankcase with oil can cause engine damage. Some applications may have other methods to perform an engine oil service reset. For assistance with the engine oil service reset contact your Perkins distributor, or your OEM. 2.

Start the engine and run the engine at LOW IDLE Use one of the following procedures after the engine oil and filter has been changed to complete an engine oil service reset: for 2 minutes. Perform this procedure to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil leaks. 3. Stop the engine and allow the oil to drain back to the oil pan for a minimum of 10 minutes.