Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 103 Maintenance Section Fan Clearance - Check Throttle Control Option 6. Turn the multi-state switch to position 1 for more than 15 seconds, but less than 20 seconds. Return the multi-state switch to position 0. The engine oil service reset procedure is complete. Note: Some application the maximum throttle position can before the throttle peddle has reached the stop. The actual maximum position of the throttle must be known before starting the procedure. With the known maximum position the middle position of the throttle can be calculated. The throttle must be positioned in the required positions for the prescribed period to perform an engine oil service reset. 7.

On completion of the sequence, the low oil warning lamp will flash three times. Each flash will be for 1 second with a 1 second interval. This sequence of flashes indicates that the warning lamp has been reset and the engine can be started and operated normally. 1. With the engine stopped. Turn the keyswitch to the ON position, and wait 15 seconds, but not more than 20 seconds. Go to step 2. 8. Turn the keyswitch to the OFF position. 9. If the procedure has been interrupted before completion, turn the power off for 20 seconds before starting again. 2. Move the throttle to the maximum position for more than 15 seconds, but less than 20 seconds. 3.

Return throttle to zero position for more than 15 seconds, but less than 20 seconds. Perkins Electronic Service Tool 4. Move the throttle to the maximum position for more than 15 seconds, but less than 20 seconds. The Perkins electronic service tool can be used to reset the oil service indicator. Connect the electronic service tool and use the menu to reset the oil service reset procedure. 5. Return throttle to zero position for more than 15 seconds, but less than 20 seconds. i04401341 Fan Clearance - Check 6. Move the throttle to the middle position for more than 15 seconds, but less than 20 seconds. Return the throttle to zero position. The engine oil service reset procedure is complete.

7. On completion of the sequence, the low oil warning lamp will flash three times. Each flash will be for 1 second with a 1 second interval. This sequence of flashes indicates that the warning lamp has been reset and the engine can be started and operated normally. There are different types of cooling systems. Refer to the OEM for information on clearance for the fan. Ensure that the engine is stopped. Ensure that the battery disconnect switch is in the OFF position. Ensure that the cooling system is full. The clearance between the cover (1) and the fan (2) will require checking.

The gap (A) between the edge of the cover and the tip of the fan blade must be checked in four equally spaced positions. 8. Turn the keyswitch to the OFF position. 9. If the procedure has been interrupted before completion, turn the power off for 20 seconds before starting again. Multi-State Switch Option 1. With the engine stopped. Turn the keyswitch to the ON position, and wait 15 seconds, but not more than 20 seconds. Go to step 2. 2. Turn the multi-state switch to position 1 for more than 15 seconds, but less than 20 seconds. 3. Return the multi-state switch to position 0 for more than 15 seconds, but less than 20 seconds. 4.

Turn the multi-state switch to position 1 for more than 15 seconds, but less than 20 seconds. 5. Return the multi-state switch to position 0 for more than 15 seconds, but less than 20 seconds