104 SEBU8726-03 Maintenance Section Fuel System - Prime Illustration 64 g02585058 Typical example Adjustment of the cover will change the clearance (gap) between the edge of the cover and the tip of the fan blade. Ensure that the cover is centralized to the fan. NOTICE Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again. The clearance (A) must be set to 10 ± 1 mm (0.39370 ± 0.03937 inch). If air enters the fuel system, the air must be purged from the fuel system before the engine can be started. Air can enter the fuel system when the following events occur:
i04366913 Fuel System - Prime The fuel tank is empty or the fuel tank has been partially drained. Note: Refer to Systems Operation, Testing, and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. The low-pressure fuel lines are disconnected. A leak exists in the low-pressure fuel system. The fuel filter has been replaced. Ensure that all adjustments and repairs are performed by authorized personnel that have had the correct training. Use the following procedures in order to remove air from the fuel system: