SEBU8726-03 105 Maintenance Section Fuel System Primary Filter (Water Separator) Element - Replace 1. Ensure that the fuel system is in working order. Check that the fuel supply valve (if equipped) is in the ON position. Note: Refer to Systems Operation, Testing, and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. 2. Operate the hand priming pump. Count the number of operations of the pump. After approximately 80 depression of the pump stop. NOTICE Ensure that the engine is stopped before any servic- ing or repair is performed. Note:
As the fuel system is primed, the pressure will increase within the fuel system and this increase in pressure can be felt during priming. 3. The fuel system should now be primed and the engine should be able to start. Remove the Element 1. Turn the fuel supply valve (if equipped) to the OFF position before performing this maintenance. 4. Operate the engine starter and crank the engine. After the engine has started, operate the engine at low idle for a minimum of 5 minutes. Ensure that the fuel system is free from leaks. 2. Place a suitable container under the water separator in order to catch any fuel that might spill. Clean up any spilled fuel. Clean the outside body of the filter assembly.
Note: Operating the engine for this period will help ensure that the fuel system is free of air. DO NOT loosen the high-pressure fuel lines in order to purge air from the fuel system. This procedure is not required. 3. Make a temporary Mark (A) across the filter before the assembly is removed. After the engine has stopped, you must wait for 10 minutes in order to allow the fuel pressure to be purged from the high-pressure fuel lines before any service or repair is performed on the engine fuel lines. If necessary, perform minor adjustments. Repair any leaks from the low-pressure fuel system and from the cooling, lubrication, or air systems. Replace any high-pressure fuel line that has leaked.
Refer to Disassembly and Assembly Manual, “Fuel Injection Lines - Install”. If you inspect the engine in operation, always use the proper inspection procedure in order to avoid a fluid penetration hazard. Refer to Operation and Maintenance Manual, “General hazard Information”. If the engine will not start, refer to Troubleshooting, “Engine Cranks but will not Start”. i05326388 Fuel System Primary Filter (Water Separator) Element - Replace Illustration 65 g03374220 Typical example 4. Install a suitable tube onto drain (3). Open the drain valve (2). Rotate the drain valve counterclockwise. Two full turns are required. Loosen vent screw (1).
Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. Note: Two complete rotations of the valve will release the valve from the filter element. 5. Allow the fuel to drain into the container. Remove the tube and install the valve into the filter element. Engage the threads of the valve into the filter element. Do not secure the valve.