Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

114 SEBU8726-03 Maintenance Section Water Pump - Inspect Belts for multiple groove pulleys must be replaced as matched sets. If only one belt is replaced, the belt will carry more load than the belts that are not replaced. The older belts are stretched. The additional load on the new belt could cause the belt to break. Check the condition of the gauges. Replace any gauges that are cracked. Replace any gauge that cannot be calibrated. i04406817 Water Pump - Inspect High Pressure Fuel Lines Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard.

Failure to follow these inspection, maintenance and service in- structions may cause personal injury or death. A failed water pump may cause severe engine overheating problems that could result in the following conditions: Cracks in the cylinder head A piston seizure After the engine has stopped, you must wait for 10 minutes in order to allow the fuel pressure to be purged from the high-pressure fuel lines before any service or repair is performed on the engine fuel lines. If necessary, perform minor adjustments. Repair any leaks from the low-pressure fuel system and from the cooling, lubrication, or air systems. Replace any high-pressure fuel line that has leaked.

Refer to Disassembly and Assembly Manual, “Fuel Injection Lines - Install”. Other potential damage to the engine If you inspect the engine in operation, always use the proper inspection procedure in order to avoid a fluid penetration hazard. Refer to Operation and Maintenance Manual, “General hazard Information”. Visually inspect the high-pressure fuel lines for damage or signs of fuel leakage. Replace any damaged high-pressure fuel lines or high-pressure fuel lines that have leaked. Ensure that all clips on the high-pressure fuel lines are in place and that the clips are not loose. Inspect the rest of the fuel system for leaks. Look for loose fuel line clamps.

Drain the water and the sediment from the fuel tank on a daily basis in order to ensure that only clean fuel enters the fuel system. Illustration 74 g02601196 Typical example (1) Weep hole Inspect the wiring and the wiring harnesses for loose connections and for worn wires or frayed wires. Check for any loose tie-wraps or missing tie-wraps. Note: The water pump seals are lubricated by the coolant in the cooling system. Visually inspect the water pump for leaks. Inspect the ground strap for a good connection and for good condition. Note: If engine coolant enters the engine lubricating system, the lubricating oil and the engine oil filter must be replaced.

Draining will remove any contaminate and will prevent any irregular oil samples. Disconnect any battery chargers that are not protected against the current drain of the starting motor. Check the condition and the electrolyte level of the batteries, unless the engine is equipped with a maintenance free battery. In order to install a new water pump, refer to the Disassembly and Assembly Manual, “Water Pump - Remove and Install”.