Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 113 Maintenance Section Walk-Around Inspection 2. Remove the air intake pipe (1). Visually inspect the piping for the presence of oil. A small amount oil will be expected, this oil is due to the breather system design. Clean the interior of the pipe in order to prevent dirt from entering during reassembly. NOTICE For any type of leak (coolant, lube, or fuel) clean up the fluid. If leaking is observed, find the source and correct the leak. If leaking is suspected, check the flu- id levels more often than recommended until the leak is found or fixed, or until the suspicion of a leak is proved to be unwarranted. 3. Check for obvious heat discoloration of the turbocharger.

Check for any loose bolts or any missing bolts. Check for damage to the oil supply line (3) and the oil drain line (2). Check for cracks in the housing of the turbocharger. Ensure that the compressor wheel can rotate freely. Check that there are no visual signs of damage to the compressor wheel. NOTICE Accumulated grease and/or oil on an engine is a fire hazard. Remove the accumulated grease and oil. Re- fer to this Operation and Maintenance Manual, “En- gine - Clean” for more information. Ensure that the cooling system hoses are correctly clamped and that the cooling system hoses are tight. Check for leaks. Check the condition of all pipes. 4. Check for the presence of oil.

If oil is leaking from the back side of the compressor wheel, there is a possibility of a failed turbocharger oil seal. The presence of oil may be the result of extended engine operation at low idle. The presence of oil may also be the result of a restriction of the line for the intake air (clogged air filters). A restriction can cause the turbocharger to slobber. Inspect the water pump for coolant leaks. Note: The water pump seal is lubricated by the coolant in the cooling system. It is normal for a small amount of leakage to occur as the engine cools down and the parts contract. 5. Install the air intake pipe to the turbocharger housing.

Ensure that all clamps are installed correctly and that all clamps are tightened securely. For more information, refer to Systems Operation, Testing, and Adjusting, “Turbocharger - Inspect”. Excessive coolant leakage may indicate the need to replace the water pump. Remove the water pump. Refer to Disassembly and Assembly , “Water Pump - Remove and Install”. For more information, consult your Perkins dealer or your Perkins distributor. Inspect the lubrication system for leaks at the front crankshaft seal, the rear crankshaft seal, the oil pan, the oil filters, and the rocker cover.

i04367583 Walk-Around Inspection Inspect the piping for the air intake system and the elbows for cracks and for loose clamps. Ensure that hoses and tubes are not contacting other hoses, tubes, wiring harnesses, etc. Inspect the Engine for Leaks and for Loose Connections Ensure that the areas around the rotating parts are clear. A walk-around inspection should only take a few minutes. When the time is taken to perform these checks, costly repairs and accidents can be avoided. Inspect the alternator belts and any accessory drive belts for cracks, breaks, or other damage. For maximum engine service life, make a thorough inspection of the engine compartment before starting the engine.

Look for items such as oil leaks or coolant leaks, loose bolts, worn belts, loose connections, and trash buildup. Make repairs, as needed: Inspect the wiring harness for damage. The guards must be in the correct place. Repair damaged guards or replace missing guards. Wipe all caps and plugs before the engine is serviced in order to reduce the chance of system contamination.