112 SEBU8726-03 Maintenance Section Radiator Pressure Cap - Clean/Replace i03639888 Radiator Pressure Cap - Clean/ Replace i04407666 Turbocharger - Inspect SMCS Code: 1052-040 Hot engine components can cause injury from burns. Before performing maintenance on the en- gine, allow the engine and the components to cool. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. NOTICE Turbocharger bearing failures can cause large quan- tities of oil to enter the air intake and exhaust sys- tems.
Loss of engine lubricant can result in serious engine damage. NOTICE When any servicing or repair of the engine cooling system is performed the procedure must be per- formed with the engine on level ground. This will al- low you to accurately check the coolant level. This will also help in avoiding the risk of introducing an air lock into the coolant system. Minor leakage of oil into a turbocharger under ex- tended low idle operation should not cause problems as long as a turbocharger bearing failure has not occurred.
When a turbocharger bearing failure is accompanied by a significant engine performance loss (exhaust smoke or engine rpm up at no load), do not continue engine operation until the turbocharger is renewed. 1. Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the radiator pressure cap. A visual inspection of the turbocharger can minimize unscheduled downtime. A visual inspection of the turbocharger can also reduce the chance for potential damage to other engine parts. Do not inspect the engine with the engine in operation. 2. Check coolant level.
Refer to Operation and Maintenance Manual, “Cooling System Coolant Level - Check”. 3. Install new radiator pressure cap. i02177969 Starting Motor - Inspect Perkins recommends a scheduled inspection of the starting motor. If the starting motor fails, the engine may not start in an emergency situation. Check the starting motor for correct operation. Check the electrical connections and clean the electrical connections. Refer to the Systems Operation, Testing and Adjusting Manual, “Electric Starting System - Test” for more information on the checking procedure and for specifications or consult your Perkins dealer or your Perkins distributor for assistance.
Illustration 73 g02603804 Typical example 1. Ensure that the turbocharger is clean and free from dirt before removing components for inspection.