Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 111 Maintenance Section Oxygen Sensor - Replace 10. Start the engine. Inspect the cooling system for leaks. Inspect the radiator for these items: Damaged fins, corrosion, dirt, grease, insects, leaves, oil and other debris. Clean the radiator, if necessary. i05324852 Oxygen Sensor - Replace Personal injury can result from air pressure. Personal injury can result without following prop- er procedure. When using pressure air, wear a protective face shield and protective clothing. Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes. Pressurized air is the preferred method for removing loose debris.

Direct the air in the opposite direction to the fans air flow. Hold the nozzle approximately 6 mm (0.25 inch) away from the radiator fins. Slowly move the air nozzle in a direction that is parallel with the radiator tube assembly. The pressurized air will remove debris that is between the tubes. Pressurized water may also be used for cleaning. The maximum water pressure for cleaning purposes must be less than 275 kPa (40 psi). Use pressurized water in order to soften mud. Clean the core from both sides. Use a degreaser and steam for removal of oil and grease. Clean both sides of the core. Wash the core with detergent and hot water. Thoroughly rinse the core with clean water.

Illustration 72 g03373217 Typical example If the radiator is blocked internally, refer to the OEM Manual for information regarding flushing the cooling system. The oxygen sensor (1) must be replaced at 3000 hours. Refer to the Disassembly and Assembly, “Oxygen Sensor - Remove and Install” for the procedure. After cleaning the radiator, start the engine. Allow the engine to operate at low idle speed for 3 to 5 minutes. Accelerate the engine to high idle. The high idle speed will help in the removal of debris and the drying of the core. Slowly reduce the engine speed to low idle and then stop the engine. Use a light bulb behind the core in order to inspect the core for cleanliness.

Repeat the cleaning, if necessary. The electronic service tool will be required in order to perform a reset after a new oxygen sensor is installed. i04245214 Radiator - Clean Inspect the fins for damage. Bent fins may be opened with a “comb”. Inspect these items for good condition: Welds, mounting brackets, air lines, connections, clamps and seals. Make repairs, if necessary. The radiator is not usually supplied by Perkins. The following text describes a typical cleaning procedure for the radiator. Refer to the OEM information for further information on cleaning the radiator. Note: Some application will require a fuel cooler to be installed.

The fuel cooler is a type of radiator that uses air to cool the fuel and the fuel cooler will require cleaning. Note: Adjust the frequency of cleaning according to the effects of the operating environment.