110 SEBU8726-03 Maintenance Section Hoses and Clamps - Inspect/Replace Inspect all hoses for leaks that are caused by the following conditions: Cracking Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Softness Loose clamps Replace hoses that are cracked or soft. Tighten any loose clamps. 1. Stop the engine. Allow the engine to cool. Check for the following conditions: 2. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap.
End fittings that are damaged or leaking Outer covering that is chafed or cut Note: Drain the coolant into a suitable, clean container. The coolant can be reused. Exposed wire that is used for reinforcement Outer covering that is ballooning locally 3. Drain the coolant from the cooling system to a level that is below the hose that is being replaced. Flexible part of the hose that is kinked or crushed 4. Remove the hose clamps. Armoring that is embedded in the outer covering 5. Disconnect the old hose. A constant torque hose clamp can be used in place of any standard hose clamp. Ensure that the constant torque hose clamp is the same size as the standard clamp. 6.
Replace the old hose with a new hose. 7. Install the hose clamps with a torque wrench. Due to extreme temperature changes, the hose will harden. Hardening of the hoses will cause hose clamps to loosen. This can result in leaks. A constant torque hose clamp will help to prevent loose hose clamps. Note: For the correct coolant, see this Operation and Maintenance Manual, “Fluid Recommendations”. 8. Refill the cooling system. Refer to the OEM information for further information on refilling the cooling system. Each installation application can be different. The differences depend on the following factors: 9. Clean the cooling system filler cap. Inspect the cooling system filler cap's seals.
Replace the cooling system filler cap if the seals are damaged. Install the cooling system filler cap. Type of hose Type of fitting material Anticipated expansion and contraction of the hose Anticipated expansion and contraction of the fittings Replace the Hoses and the Clamps Refer to the OEM information for further information on removing and replacing fuel hoses (if equipped). The following text describes a typical method of replacing coolant hoses. Refer to the OEM information for further information on the coolant system and the hoses for the coolant system.